CPE & Access Gateway Products MP-202 Uživatelský manuál stáhnout pdf (Strana 9)

Application Note 3. DSP Packet Recording

Version 2.6.1 9 June 2008

Note: The packet recording captures are still active when the TDM and or

network packet recording are activated.

¾ To activate the TDM input recording:

1. If the packet recording tool is already activated, use the same command for packet

recording (otherwise, skip to Step 2):

Gateway> dsp_cmd pr 0 1 10 16 2 4

2. If the packet recording tool is not activated, perform the following:

a. Perform steps 1 through 3 for packet recording in Section 3 on page 7.

b. Run the dsp_cmd pr command again.

Figure 3-3: Wireshark Capture with TDM Recording and Packet Recording

¾ To activate both TDM input and network recording:

1. If the packet recording tool is already activated, enter the packet recording command

twice, as shown below (otherwise, skip to Step 2):

Gateway> dsp_cmd pr 0 1 10 16 2 4

2. If the packet recording tool is not activated, perform the following:

a. Perform steps 1 through 3 for packet recording in Section 3 on page 7.

b. Run the dsp_cmd pr command twice.

¾ To activate RTP recording:

1. If the packet recording tool is already activated, use the same command three more

times (otherwise, skip to Step 2):

Gateway> dsp_cmd pr 0 1 10 16 2 4

2. If the packet recording tool is not activated, perform the following:

a. Perform steps 1 through 3 for packet recording in Section 3 on page 7.

b. Run the dsp_cmd pr command three times.

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

CPE & Access Gateway Products MP-202 Uživatelský manuál Strana 9